Page 47 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
9. Standard System Set Up
9.1 Components Check List
Required Components
ITEM
O.N.
NIOSH P/N
QTY
DESCRIPTION
1
2081-03
03531001, 03531021, 01031269, 2590-05
1ea
MAXAIR CAPR Helmet Assembly
2
2365-02SM or
2365-02ML
01031316 OR 01031291
40/
Box
Disposable Lens Cuff (DLC) - Small/
Medium (SM) or Medium/ Large (ML)
3
2500-36TSC
01532104
1ea
Li-Ion Battery
4
2600-01
01432089
1ea
Li-Ion Battery Charger
5
2000-76
2000-76
1ea
Battery Belt
9.2 Setting Up
1. Check the position of the Headband Comfort Strips. (See Section 7 for Comfort Strip assembly and replacement instructions).
2. Adjust the Rear Headband Ratchet Adjustment Knob counterclockwise to expand the Headband circumference to ensure the
Helmet will fit easily before donning. (See Section 6 on Donning for more detail.)
3. Adjust the Height Adjustment Snaps on the Helmet Liner to ensure proper and secure fit of the CAPR System on the head
and good visibility of the Safety Status Indicator LEDs. (See Section 6 for more detail.)
4. Check to ensure that the Helmet Power Cord is firmly attached to the Helmet Power Cord Connector.
9.3 Assemble and Disassemble Components
CAUTION
Prior to operation, review all components’ Instructions For Use regarding set-up, assembly/disassembly,
and don/doff in sections 6,10-19.
The general assembly/disassembly steps are as follows:
STEP
ASSEMBLE
STEP
DISASSEMBLE
4
Assemble the 2061-08
Filter Cover Cap to the Helmet.
(Alternate Covers are
appropriate for other
configurations.)
2
If required, disassemble
the 2061-08 Filter Cover
Cap from the Helmet.
3
Snap off the 2051-07 Cage
and snap on the 2164-10 Filter
Cartridge from the Helmet.
(Alternate Filter Cartridges may
be used.)
3
If required, disassemble
the 2164-10 Filter
Cartridge from the Helmet.
(Dispose appropriately as
hazardous waste.)
1
Inspect and ready the
2081-03 Helmet for use.
5
If required, prep the
2081-03 Helmet for
storage.
2
If required, assemble the
2071-06 Helmet Liner to the
Helmet.
4
If required, disassemble
the 2071-06 Helmet Liner
to the Helmet.
5
Assemble the DLC to Helmet.
(Alternate Face/Head covers
may be used for other
configurations.)
1
Disassemble the DLC.
(Dispose of the DLC
appropriately as
hazardous waste.)
