2.2.2 The KeyPad
PCE-MCA 50 has nine different keys. The key description is given below.
This key has different functionalities in different menu. And that
is shown on Bottom Left Part of Display.
Pulse Resetting Shortcut: The counter may be cleared (zeroed)
by long Pressing F1 key for 3 sec during Pulse Measurement
Only.
This key has different functionalities in different menu. And that
is shown on Bottom Right Part of Display.
This key is use to scroll down to the next parameter. And also
for decrementing the value of digit in Editbox.
This key is use to scroll up to the previous parameter. And also
for incrementing the value of digit in Editbox.
This Key is use for Entering into the MENU Page from Run
Page.
And Also for Saving Edited Parameter to the memory.
This key is use to log current reading in memory if device is on
Run Page& Log Mode is Manual. (In other Page than Run
Mode, this key is use to come directly to Run Page.
Long presses (Approx.2 Sec) on this key will ON-OFF the Unit.
This key is used to go in Screen 1 setup menu page.
This key is used to go in Screen 2 setup menu page.
This key is used to switch between measure and source mode
(Only applicable for T/C,mV and RTD Measure / Simulation).
