28
Magnum 1500 user manual
3. Being careful to avoid straining any wires, pull the module gently
outwards and to one side. Note the position of the module’s wiring
connector, with the wires facing away from the locking tab on the circuit
board connector, and disconnect it from the 6-pin plug on the circuit
board inside the housing. Then remove the module completely.
4. The DMX interface module has a 3-pin female wiring connector. This
must be connected to the 3-pin male connector on the circuit board –
not
the 6-pin connector used by the remote control module (see
illustration).
5. Hold the DMX module up to the housing and push the DMX interface
connector in so that its wires face away from the locking tab on the
circuit board connector. The locking ridge molded into the end of the
DMX interface connector must face towards the locking tab on the
circuit board connector. The wiring connector is an easy sliding fit. If
you need to force it, you may be trying to insert it the wrong way round.
Remove 6-pin remote
control connector
Insert 3-pin DMX
interface connector
Locking tab