Operation
19
R e m o t e c o n t r o l o p e r a t i o n
The remote control supplied with the Magnum 1500 gives feedback on
the status of the machine. It also allows you to create instant fog or set a
timer to create fog at intervals. Duration and volume of fog production can
be varied during timer operation.
• Use the TIMER knob to set fog
output run times from zero to 10
(maximum).
• Use the LEVEL knob to set the
volume of fog output from zero to
10 (maximum).
• If you set the TIMER knob to 0,
you can produce instant fog by
pressing the FOG button.
• The TIMER indicator lights when
the timer function is active.
• The READY indicator lights when
the Magnum 1500 is ready to
produce fog.
• The HEAT indicator lights when
the heating element is active. It
should light continuously during
pre-heating, light occasionally
during operation and light
continuously during re-heating.
Note that the Magnum 1500 is not designed to give continuous output at
the highest levels. If you set the output level to 10 (maximum), output will
be interrupted after approximately 50 seconds while the machine re-
heats. Re-heating takes less than 2 minutes. The level at which output is
continuous will vary depending on ambient and fluid temperatures, but
output levels up to at least 5 are normally continuous.
R e s e t t i n g t h e t h e r m a l c u t o u t
The Magnum 1500 is fitted with a thermal cutout to protect against
overheating. If for any reason the heating element temperature exceeds
normal operating level, the thermal cutout shuts down the power.
1
Off
2
3
4
5
6
7
8
9
10
1
0
2
3
4
5
6
7
8
9
10
Timer
Fog
Level
Timer
Ready
Heat