M&C SP Series, Instruction Manual

Page: 41 / 59

www.mc-techgroup.com SP2000, SP2300, SP2400 | 1.00.03 41

Clean filter chamber.

It is now also possible to rod through the probe tube in order to remove deposits. Caution danger of breakage
when handling probe tubes made of alu-oxide !

Replace filter holder with lid, turn handle C into position F and tighten lid with toggle A again.

Replace the protective hood and fasten with quick-release fasteners.

Open (if available) ball valve.
17.2 CHANGE OF THE OPTIONAL PREFILTER
For changing the prefilter the complete probe unit has to be dismounted and removed out of the process:
Warnung
When working during operation:
High surface temperatures!
Touching the surfaces can result in burns. Wear protective gloves and any unau-
thorized access to the probe must be made impossible!

Loosen the 4 flange nuts and remove if possible the fixing screws (not for prefilters V12..., adapter flanges
or SP30-H....)

Extract probe with prefilter out of the process.

Let prefilters cool and than screw out resp. for prefilters V12... remove the 4 flange nuts on probe side (see
also Fig. 6).

Change or clean prefilter.
Note
Prefilters depending on type and degree of contamination can be partly cleaned
mechanically or in an ultra sonic bath and reused.