M&C SP Series, Instruction Manual

Page: 18 / 59

18 SP2000, SP2300, SP2400 | 1.00.03 www.mc-techgroup.com
Figure 2 Mounting possibilities SP2000..., SP2300-H, SP2400-H
Before mounting, the probe must be adjusted to the existing operating conditions.
The existing operational parameters are to be checked accordingly prior to commencing mounting work.
Low-excess pressure situation mbar bar
Process temperature °C, Min. °C Max.
Dust loading g/m3
Dust composition – grain size μm
Gas composition corrosive toxic explosive
Parameters to be measured, e.g. O
2
, CO,
SO
2
, NO
X
,..,
Vol.%
mg/Nm3
ppm
Necessary gas flow l/h, Min. l/h, Max.
Necessary T
90
-time s
14 MOUNTING
M&C SP2000 probes are designed for stationary use and if properly selected and mounted a long service life and
minimum maintenance are guaranteed.
A horizontal operating position with approx. 10° inclination to the process is recommended.
14.1 CHECK OF THE FILTER ELEMENT
Before starting the filter element has to be checked for tight fit.