M&C SP Series, Instruction Manual

Page: 19 / 59

www.mc-techgroup.com SP2000, SP2300, SP2400 | 1.00.03 19
Figure 3 Cross-sectional drawing SP2000-H
Removing the filter housing lid to check or change the filter element has to be done as follows :

Remove the probe's protection shield after opening the two clamping devices;

Turn toggle screw „ A “ approx. 1 turn counter-clockwise, that the filter housing lid will lift up;

Turn handle „ C “ in position „ E “;

Turn clamp „ B “ counter-clockwise in direction „ G “;

Take toggle screw „ A “ and pull out the filter housing lid;

Check tight fit of filter element and tighten it if necessary (hand tight) or change filter element and correspond-
ing sealings;
Warning
When working during operation:
High surface temperatures!
Touching the surfaces can result in burns.
Wear protective gloves and any unauthorized access to the probe must be made
impossible !

Push in the filter housing lid into the filter area;

Turn clamp „ B “ clockwise and turn with the handle „ C “ the ringsscrew „ D “ in position „ E “, that the clamp „ B “ will
latch into the ringscrew „ D “ and the threaded bolt „ H “. It could be neccessary to move the filter housing lid a
little bit forward and backward;

Turn handle „ C “ in position „ F “ and fasten the filter housing lid by turning the toggle screw „ A “ clockwise by
hand.