MANATEC Fox 3D Smart Mobile PT, Service Manual, Page: 27 / 104

Ref.: 3DWA - SM Ver.1.8
24
Bracket locking
Grub screws - Top
Beam
mounting
provisions
Bracket
locking
Knobs
Beam
mounting
bracket
Bracket locking
Grub screws – Bot
In-Lift model
Fix the Stopper plates (1) with the front face of both the Lift platforms.
1
2
3
4
4
Fig. 17
Fix the Extension spacers (2) with both the front face of Lift platform and then
fix the respective Camera column frames (3) with the Spacer.
Fix the Cable routing tubes (4) with both the Column frames.
4.1.2. HORIZONTAL BEAM (NA for In-Lift model)
Horizontal beam is pre-assembled and is factory calibrated which can
be placed into service shortly after installation and setup
Place the Horizontal beam over the seating plate / Bracket in Vertical column /
Wall mount bracket and fix it using fasteners supplied. Use Jack screws for
adjustment, if required.
In case of VH model, fix the Beam mounting bracket
with Vertical column at the desired height
using the provisions given in Vertical column
by pulling out the Lock knobs and moving the
Bracket to desired location. Now lock the
knobs followed by top Grub screws first &
then the bottom screws.
Now fix Horizontal beam over the
Bracket.
Camera, LED driver & Hub board
and IR LED boards are internally
connected in the Horizontal beam.
For AVH model
, open the Hub board cover
and connect the USB Type-B Male connector
to LED Driver & Hub board. Connect 5Pin BSM
connector from Interface box to the Horizontal
beam at the rear side.
Fig. 18