35
i) Laying the cables
Lay the cables as shown in the illustrations. Use the supplied cable ties for this purpose. After the cable ties have been tightened, cut off the protruding part of
the cable tie. A clean cable laying gives the robot a very high-quality appearance!
As long as you have not finished aligning the cables, you should not tighten the cable ties too tightly. This way you can make small corrections easily.
Required tool:
Electronic side cutter
Figure 56
Figure 57
Summary of Contents for MF-4992453
