Maker Factory MF-4992453, Operating Instructions Manual, Page: 28 / 68

28
Figure 39 shows the top side of the robot!
Figure 39
Figure 40 shows how the dowel pins are only slightly pressed in to fix
them in the plastic.
Only when all the dowel pins have been fixed in the holes of the plastic
holders are they pressed in at a distance (2.5 mm).
To achieve the correct distance, place the Hexagon key between the
bearing and the plastic holder and press the cylinder pins into the plastic
holder with moderate force.
If a cylindrical pin has been pressed in too far by mistake, you can correct
this with a wide slotted screwdriver by gently levering it out. Make sure,
however, that the aluminium parts are not damaged (scratched).
After all bearings have been pressed in and adjusted to the correct dis-
tance, screw them together with the spacers.
Figure 41 shows how to set the correct distance using the 2.5 mm hexa-
gon wrench as the spacer.
Figure 40
Figure 41