Page
59
of
63
Step 8
–
The E-Lower Cord can now be removed through the slit in the Chassis.
Refitting / Replacement
Step 9 - Refitting is a reversal of the removal process noting the following point:
A)
When inserting the E-Lower Cord through the Slit, ensure the labelled face is facing the
Lift Motor.
B)
To re-attach the Toggle Switch to the Chassis, you must align the Toggle Switch threaded
holes with the holes in the Chassis and attach using the 3mm Allen Key and M5 x 10 CSK
Screws.
Traverse Idle Gear
Within this section it will explain the correct procedure on removing and reinstalling the
Traverse Idle Gear for servicing procedures or replacement.
Removal
Step 1 - Remove external covers off the hoist (refer to section 9.1)
Step 2
–
Remove the Wheels from the hoist (refer to section 9.11)
Step 3
–
Using a 2mm Allen Key, Remove the M3x12 Screw and M3 Nyloc Nut to release the
Traverse Idle Gear.
Step 4 - Split the male and female parts of the Traverse Idle Gear as shown and remove.
Ensure to grab the washers placed between each piece of the Traverse Idle Gears.
Summary of Contents for TX440 Advanced PT
Page 10: ...Page 10 of 63...
Page 11: ...Page 11 of 63...
