Page
30
of
63
Batteries
This section will instruct the correct procedure on how to remove and replace the Batteries.
Removal
Step 1
–
Remove external covers of the Hoist. (refer to section 9.1)
Step 2 - Disconnect the power lead from PCB. (See section 9.2 PCB for reference)
Step 3
–
Release the Velcro straps (arrowed) to give access to the Batteries.
Step 4
–
Detach the power cables from the battery terminal. (Arrowed)
Step 5
–
Remove both batteries from their brackets.
Refitting / Replacement
Step 6 - Refitting is a reversal of the removal process noting the following points:
A)
Make sure the battery terminal are on the outer edge and the terminals are pointing
inwards.
B)
Ensure the positive lead (Red) goes to the correct side of the Hoist (Circled) and the
negative lead (Black) goes to the correct side of the Hoist (Circled).
C)
Ensure Velcro is installed in the below fashion.
RED LEAD
BLACK LEAD
Summary of Contents for TX440 Advanced PT
Page 10: ...Page 10 of 63...
Page 11: ...Page 11 of 63...
