Page
53
of
63
Traverse Shaft and Idle Gear (Powered Models Only)
Within this section it will explain the correct procedure on removing and reinstalling the
Traverse shaft and Idle Gear for servicing procedures or replacement.
Removal
Step 1 - Remove external covers off the hoist (refer to section 9.1)
Step 2
–
Remove the PCB from the hoist (refer to section 9.2)
Step 3
–
Remove the Battery from the battery brackets (refer to section (9.3)
Step 4
–
Remove the Traverse Motor from the hoist (refer to section (9.4)
Step 5 - Using a small slotted screwdriver remove the 8mm E-clip from the Traverse Shaft
Step 6
–
Remove the washer from the Traverse Shaft
Step 7
–
While supporting the two spacers and Idle Gear, labelled 1, 2 and 3 in the image
below, slide the drive shaft out of the Chassis
Step 8
–
Remove the Spacers and Idle Gear from the Chassis.
1
2
3
Summary of Contents for TX440 Advanced PT
Page 10: ...Page 10 of 63...
Page 11: ...Page 11 of 63...
