Page
19
of
63
Hoist doesn’t charge –
Constant Charge
Do not operate the Hoist and allow the Hoist to charge at its current location. If the display does not
show “charging” or the LED does not flash orange, follow the Troubleshooting Guide below.
Troubleshooting Guide
1.
Check the Constant Charge Charger is turned on at the power supply
–
the charging unit LED
should show a steady green light when turned on, and flashing orange when the Hoist is
charging.
2.
Check that the Constant Charge Beak is in contact with the Ceiling Track charge strips.
3.
Check Charger wiring for damage, e.g. cuts and breaks.
4.
Check Voltage and Current through the Charging Dock.
5.
Check the Constant Charge Beak is not damaged, e.g. Cracks, breaks.
6.
Check the Constant Charge Strips within the Track are not damaged, e.g. poor connections,
broken strips.
7.
Check Charging Beak wiring from the beak to the PCB for damage or disconnection.
8.
Check PCB for damage near the Charging Beak connection point, e.g. blown components.
9.
Check the Batteries output using a Battery Tester.
10.
Replace Charging Beak
11.
Replace Charger
12.
Replace PCB
Action Guide
1.
Turn the Plug Switch at the wall on.
2.
Inspect the Beak for damage that may cause the lowered height. Replace if necessary.
3.
Replace Charger Assembly. See Installation Manual for Charger installation.
4.
Use a Voltmeter and Ammeter to determine the Voltage and Amps of the Charging Dock, the
voltage should show 24VDC. Amperes should show 1A. If there is no Voltage or Current
running through the Charger, check the Fuse in the Plug. Replace if necessary. If there is no
fault to be found, replace the Charging Doc Unit. See the Installation Manual to install
Charger
5.
Replace the Charging Beak. See Section 9.12
6.
See the Installation Manual for the specific ceiling track for service and repairs to the
constant charge strip.
7.
If the wire is damaged, replace the beak (see section 9.12), if wiring is disconnected from
board, re-connect correctly (see section 9.12)
8.
Replace the PCB
–
See section 9.2
9.
If Batteries or non-responsive, replace the batteries.
10.
See section 9.12 for Charging Beak replacement.
11.
See Charger Installation within the Installation Manual.
12.
See section 9.2 on PCB replacement.
Summary of Contents for TX440 Advanced PT
Page 10: ...Page 10 of 63...
Page 11: ...Page 11 of 63...
