Page
48
of
63
9.12.3
QRT System Charging Beak
Within this section it will explain the correct procedure on removing and reinstalling the QRT
Systems Charging Beak for servicing procedures or replacement.
Removal
Step 1
–
Disconnect the Charging Beak from the external cover plug in.
Step 2
–
Cut the cable tie that secure the wire to the Chassis.
Step 3
–
Using a Pozi Screwdriver, remove the screws to release the Charging Beak.
Refitting / Replacement
Step 4 - Refitting is a reversal of the removal process noting the following point:
A)
One cable tie is required!
–
Re-secure the Wire with cable tie as instructed below:
Pass through the cable tie (100x2.5mm) through the hole and tie to secure the wire to the
chassis. Snip the surplus cable once secured.
Summary of Contents for TX440 Advanced PT
Page 10: ...Page 10 of 63...
Page 11: ...Page 11 of 63...
