214323
52
Revision B
Table 3.4
Illustrated Reel Settings (continued)
Cam Setting Number
(Finger Speed Gain)
Reel Position
Number
Reel Finger Pattern
3 (30%)
3 or 4
1001821
4 (35%)
2 or 3
1001822
The following points describe the expected results for certain reel position adjustments:
•
To position the fingers closer to the ground, adjust the reel forward , while tilting the header back.
NOTE:
Fingers or tines will dig into the ground at extreme reel-forward positions, so adjust the skid shoes or the header angle
to compensate.
•
To prevent plugging on the cutterbar in the thinner crops, adjust the reel aft.
–
Increase the header angle to position the reel closer to the ground
–
Decrease the header angle to position the reel farther from the ground
•
For maximum stubble height in the lodged crop, raise the header, increase the header angle, and position the reel fully
forward.
•
For the maximum crop carrying capacity (largest area of exposed draper between the reel and the header backsheet)
position the reel in the farthest forward position.
•
For the minimum crop carrying capacity (smallest area of exposed draper between the reel and the header backsheet)
position the reel in the farthest aft position.
NOTE:
Due to the nature of the reel cam action, at higher cam settings the reel finger tip speed at the cutterbar is higher than the
reel speed.
Summary of Contents for FD75
