214323
409
Revision B
1001478
B
C
D
A
A
Figure 6.118: Stub Guards
5.
Position the plastic wearplate (if applicable), replacement
guard (B), adjuster bar (D), hold-down (C), and install bolts
and nuts (A). Do
NOT
tighten.
6.
Check and adjust the clearance between the hold-downs
and the knife. For instructions, refer to
Adjusting Knife Hold-Downs, page 410
Replacing center guards
NOTE:
The guard at the center of a double-knife header (where the two knives overlap) requires a slightly different replacement
procedure.
7.
Shut down the engine, and remove the key from the ignition.
Summary of Contents for FD75
