UNLOADING AND ASSEMBLY
Form 169007
22
Revision
D
STEP 7.
CONNECT
HYDRAULICS
M150, M200 and M205 Windrowers may not be
factory equipped with D Series header and reel
hydraulics as shown below. If not, proceed to
step a. to install optional drive/lift kits. If already
equipped, go to step b.
NOTE
Windrowers equipped with D-Series
hydraulics have four header drive hoses
on the LH side, and up to five reel drive
hoses on the RH side.
a. If required, configure the M Series windrower to
run a D-Series draper header by installing optional
drive/lift kits. See table below for appropriate
kit(s). Kits include all necessary hardware and
installation instructions, and should have been
provided with the windrower shipment.
TRACTOR
OPTIONAL KITS FOR DRAPER HEADER
REEL
DRIVE/LIFT
REEL
FORE/AFT
REVERSER
COUPLER
M100
B5426 B5194 -- --
M105
B5577 --
--
M150
B5426 B5194
B4656
--
M155
B5577 --
M200
B5426,
B4651
B5194 --
M205
B5491 B5496
B5492
B5497
b. Connect header drive hydraulics (A), and electrical
harness (B) to header as follows:
1. Check connectors, and clean if required.
2. Disengage, and rotate lever (C) counter
clockwise to “fully up” position.
3. Remove cap securing electrical connector (B)
to frame.
4. Move hose bundle (A) from windrower around
hose support on header.
5. Push hose connectors onto mating receptacle
until collar on receptacle snaps into lock
position.
6. Remove cover on electrical receptacle.
(continued next page)
C
A
B
KNIFE DRIVE
DRAPER DRIVE
RETURN
CASE DRAIN
(DOUBLE KNIFE)
ELECTRICAL
HEADER DRIVE
REEL HYDRAULICS
