UNLOADING AND ASSEMBLY
Form 169007
23
Revision
D
7. Push electrical connector onto receptacle, and
turn collar on connector to lock it in place.
8. Attach cover to mating cover on windrower
wiring harness.
9. Lower lever (C), and engage in “down”
position.
c. Check that hose support is positioned so that top
bolt is ”midway” in slot, and lower bolt is in forward
hole. Loosen bolts, and adjust as required.
d. Connect reel hydraulics (D) as follows:
1. Check connectors, and clean if required.
2. Open cover (E) on header receptacle.
3. Push in lock button (F), and pull handle (G) to
“half open” position.
4. Remove hose bundle with multi-coupler (D)
from windrower, position onto header
receptacle.
5. Push handle (G) to engage pins on connector.
6. Push handle away from hoses until lock
button (F) snaps out.
CAUTION
Check to be sure all bystanders have cleared
the area.
e. Start engine, and raise and lower header and reel
a few times to allow trapped air to pass back to
the reservoir.
f. Stop
engine.
NOTE
It is not necessary to bleed the system by
loosening fittings.
C
D
E
F
G
F
G
D