UNLOADING AND ASSEMBLY
Form 169007
28
Revision
D
STEP 11. INSTALL CROP
DIVIDERS
A. D60
a. At divider storage location, remove shipping wire
from crop divider.
b. Lift divider to disengage lugs (A) at lower end, and
then lower it slightly to disengage pin (B) from
endsheet.
c. Position crop divider as shown by locating lugs (A)
in holes in endsheet.
d. Lift forward end of divider until pin (C) at top of
divider engages, and closes latch (D).
e. Push safety lever (E) down to lock pin in latch.
f.
Check that divider does not move laterally. Adjust
bolts (F) as required to tighten divider, and remove
lateral play when pulling at divider tip.
g. Remove divider rods from shipping location on
header endsheet.
h. Position divider rod (G) on tip of crop divider as
shown, and tighten bolt (H).
i.
Repeat above steps for other end of header.
B
A
A
C
E
D
F
G
H
