UNLOADING AND ASSEMBLY
Form 169007
21
Revision
D
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT: OPTIONAL FOR M150, M155,
M200, M205
1. Adjust position of center-link cylinder with the
REEL UP, REEL DOWN, and HEADER TILT
switches on the GSL to position hook above
the header attachment pin.
2. Lower center-link onto header with REEL
DOWN switch until it locks into position
(handle is “down”).
b. Raise the header fully with HEADER UP switch on
the GSL. Stop engine, and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
c. Engage lift cylinder stops on both lift cylinders.
d. Install pin (E) through header leg, (engaging
U-bracket in header leg) on both sides.
e. Raise header stand (F) to storage position by
pulling pin (G), and lifting stand into “uppermost”
position. Release pin (G).
f.
Remove pin from storage position (H) in linkages
on both sides, and insert in hole (J) to engage
float springs. Secure with hairpin.
g. Disengage lift cylinder stops.
CAUTION
Check to be sure all bystanders have cleared
the area.
h. Start engine, and activate HEADER DOWN switch
on GSL to lower header fully.
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
i.
Stop engine, and remove key.
H
J
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
F
G
E
