LubriMist
®
Model JD
Oil Mist Generating System
Installation and Operating Manual
Page 51 of 152
The display changes to the next prompt message or normal screen only after the correct button is pressed.
The run mode screen is displayed at any time by pressing the “CLEAR” button. The following diagrams
illustrate the proper key sequences for entering custom alarm and set point values. The diagrams use the
following logic symbols.
This symbol is used to indicate the start and end of each key sequence.
The following illustrations assume that key sequences are initiated and
completed while the unit is operating normally.
This symbol is used to indicate that an operating variable or message is
being shown on the display.
This symbol is used to indicate where an input operation is required by
the user.
This symbol indicates where a decision is to be made. The question is
indicated in the border of the symbol.
NOTICE:
All alarms, heaters and solenoids are fully operational while the
controller is in "Program Mode". New values are not recognized
until the new value is entered into memory by selecting the
“ENTER” key.
P R E S S
< f u n c t i o n >
RUN MODE
IN NORMAL
PROGRAM
XXX
SET <VARIABLE>
Y E S
N O
