LubriMist
®
Model JD
Oil Mist Generating System
Installation and Operating Manual
Page 49 of 152
The following diagram illustrates the proper key sequences for viewing the alarm and set point values. The
diagram uses the following logic symbols.
This symbol is used to indicate the start and end of each key sequence. The
following illustrations assume that key sequences are initiated and completed while
the unit is operating normally
This symbol is used to indicate that the operating variable or message is being
shown on the display.
This symbol is used to indicate where the user requires an input operation.
This symbol indicates where a decision is to be made. The question is indicated in
the border of the symbol.
<VARIABLE>
CUT-OUT XXX
<VARIABLE>
LOW XXX
ENTER
PRESS
ENTER
PRESS
(1)
YES
DOES VARIABLE
HAVE CONTROL
SET POINT
NO
<FUNCTION>
PRESS
KEY
(3)
IN NORMAL
RUN MODE
SET KEY
PRESS
PROGRAM
SET XXX
<VARIABLE>
HIGH XXX
<VARIABLE>
PRESS
ENTER
PRESS
ENTER
NOT ALLOWED
DOES VARIABLE
HAVE CUT-OUT
NOT ALLOWED
ADJUSTMENTS
SET POINT
NOT ALLOWED
ADJUSTMENTS
SET POINT
YES
PROGRAM
IN NORMAL
RUN MODE
(1)
SET POINT
PROGRAM
IN NORMAL
RUN MODE
NO
SET POINT
NOT ALLOWED
ADJUSTMENTS
SET POINT
ADJUSTMENTS
Notes
1.
Applies Only To Air / oil Heater
Sequence Diagram For Viewing Operating Variable
Set Points
RUN MODE
IN NORMAL
PROGRAM
XXX
SET <VARIABLE>
P R E S S
< fu n c tio n >
YES
NO