LSIS LSLV0055H100-4COFN, Manual

Page: 258 / 610

Learning Advanced Features
244
Grou
p
Code Name LCD Display Parameter Setting Setting
Range
Unit
IN
65–
71
Px terminal
configuration
Px Define(Px: P1–
P7)
28 2nd Motor 0-55 -
2
nd
Motor Operation Setting Details
Code Description
IN-65–71 Px
Define
Set one of the multi-function input terminals (P1–P5) to 26 (2nd Motor) to
display the M2 (2nd motor group) group. An input signal to a multi-function
terminal set to 2nd motor will operate the motor according to the code
settings listed below. However, if the inverter is in operation, input signals to
the multi-function terminals will not read as a 2nd motor parameter.
PRT-50 (Stall Prevent) must be set first, before M2-28 (M2-Stall Lev)
settings can be used. Also, PRT-40 (ETH Trip Sel) must be set first, before
M2-29 (M2-ETH 1 min) and M2-30 (M2-ETH Cont) settings.
Parameter Setting at Multi-function Terminal Input on a 2nd Motor
Code Description Code Description
M2-04 Acc Time Acceleration time
M2-15 M2-
Efficiency
Motor efficiency
M2-05 M2-Dec
Time
Deceleration time M2-17 M2-Rs Stator resistance
M2-06 M2-
Capacity
Motor capacity M2-18 M2-Lsigma Leakage inductance
M2-07 M2-Base
Freq
Motor base frequency M2-25 M2-V/F Patt V/F pattern
M2-08 M2-Ctrl
Mode
Control mode
M2-26 M2-Fwd
Boost
Forward torque boost
M2-10 M2-Pole
Num
Pole number
M2-27 M2-Rev
Boost
Reverse torque boost
M2-11 M2-Rate
Slip
Rated slip M2-28 M2-Stall Lev Stall prevention level
M2-12 M2-Rated
Curr
Rated current
M2-29 M2-ETH 1
min
Motor heat protection 1
min rating
M2-13 M2-Noload
Curr
No-load current
M2-30 M2-ETH
Cont
Motor heat protection
continuous rating
M2-14 M2-Rated Motor rated voltage