LSIS iG5H Series, Manual

Page: 37 / 225

24
Programming Keypad & Basic operation
Moving to other parameter groups
is only available in the first code of each group as

the figure shown below.
Moving to other groups using the Right
(

) key
Moving to other groups using the Left (

)
key
* Target frequency can be set at 0.0 (the 1st code of drive group). Even though the preset value
is 0.0, it is user-settable. The changed frequency will be displayed after it is changed.
How to move to other groups at the 1st code of each group

1
The 1
st
code in Drive group “0.00”
will be displayed when AC

input power is applied.
Press the right arrow (

) key once to go to Function group 1.

2
The 1
st
code in Function group 1 “F 0”
will be displayed.

Press the right arrow (

) key once to go to Function group 2.

3
The 1
st
code in Function group 2 “H 0”
will be displayed.

Press the right arrow (

) key once to go to I/O group.

4
The 1
st
code in I/O group “I 0”
will be displayed.

Press the right arrow (

) key once again to go to Application

group.
5
The 1
st
code in Application group “A 0”
will be displayed.

Press the right arrow (

) key once again to return to Drive

group.
6 Return to the
1
st
code in Drive group “0.00”
.


If the left arrow key (

) is used, the above will be executed in the reverse order.
www.barghmaher.ir