LNS GT 112-E, Instruction Manual

Page: 107 / 201

8 - 32
Chapter 8 OPERATION
GT 112-E
＊
Refer to the timing chart <4> on 8.6.2.1
33 R3 turns ON at EOB and turns OFF
(Refer to INTERFACE17, 18, 19, 20, 31, 32 for related setup)
Defines when R3 turns OFF.
1 R3 signal turns OFF during end of Bar when A3
signal is activated and the pusher retracts back
to home position.
2 R3 signal turns OFF when the new bar is
loaded into the channel.
＊
Refer to the timing chart <4> on 8.6.2.1
34 R2 While In Synchronization Ready
Defines if R2 signal turns ON when headstock
synchronization is enabled.
1. R2 signal is OFF.
2. R2 signal is pulsed for 1 second to confirm M-code
for headstock synchronization enabled.
43 R5 is
Defines function of R5 signal
1
Used for Auxiliary End of Bar signal.
2 Used for spindle Inching signal
3 Used for Magazine Empty
44 Lathe door signal logic setup