Linux MEGAsys, User Manual

Page: 39 / 108

35
Alarm Record Triggering
The following shows how to use Record Alarm:
1. Click the “
Alarm
” Tab first.
2. From the “ General ” tab select the “ Duration ” for motion detection triggering and click the checkbox next
to “ AdjustFrameRateTo ” to select the frame speed for the motion detection.
Figure 8-2: General Field
3. Select the appropriate triggering event for alarm recording (“ Camera ”, “ Din ”)
4. Select the entire “ Enable ” field for to enable 24 hours recording duration. To set up other record durations,
tick off the entire “
Enable
” field first, then select “
Enable
” under “
Trigger Period
” to set the record
duration.
5. Click “ Record ” Tab.
6. Click “
Add
” button.
7. Click “ Apply ” , then “ OK ” to activate.
Alarm Sound Triggering
Activating the Alarm Sound parameter enables sounding of the alarm at the time of alarm condition
detection. Follow the instructions below to set the Alarm Sound.
1. Click the “ Alarm ” Tab first.
2. Select the “ Camera ”, “ Din ”, “ Disk full ”, “ Disk failure ”, or “ No signal ”.
3. Select “ Enable ” or “ Enable ” “ Trigger Period ”.
4. Click the “ Sound ” Tab.
Figure 8-3: Sound Tab
5. Click the “ Select ” button to choose alarm sound from the sound list window.