UMX-TPS-TX100 series
User’s Manual
Section 4. Installation
Page 29 / 127
Step 1.
Connect the
“TPS OUT+PoE” port of the transmitter to the “TPS+PoE” output port
of the TPS-PI-1P1 by a CATx cable.
Step 2.
Connect the receiver (or the Matrix input board) to the power injector by a CATx
cable via the TPS connector.
Step 3.
Connect the desired video and audio source(s) to the input connector(s) of the
transmitter.
Step 4.
Optionally connect the transmitter to a Local Area Network (LAN) in order to control
the device. More information about establishing the connection can be found in
section
Step 5.
Optionally connect a serial device
to the transmitter’s RS-232 port.
Step 6.
Power on the devices.
Info: When both local adaptor and remote power injector are connected to the wall plate
transmitter, the local adaptor will be used as a power source. When the adaptor is
disconnected from the wall plate, the device reboots and the remote power will be used.
4.5. Firmware indication
After being powered on, the transmitter lights up all LEDs, then displays its firmware version
using three LEDs on the front panel: the upper three in the left column. The top LED means
the first number of the firmware version
– actually this is the main version. The second and
the third LEDs from the top indicate the second and the third numbers of the firmware
version which mean the subversions.
Example (UMX-TPS)
Below figure shows an UMX-TPS-TX140 with firmware version 1.0.1.
The process after the device is switched on or rebooted is the following:
All the LEDs are lit
→ VGA, HDMI and DP video LEDS are off for 1 sec → VGA LED blinks
once the first number (1) → HDMI LED stays dark showing the second number (0) → DP
LED blinks once showing the third number (1) → Front panel LEDs are off → Last state of
the device is restored and displayed on the LEDs.
Example (WP-UMX-TPS)
Below figure shows a WP-UMX-TPS-TX130-US with firmware version 1.0.2.
The process after the device is switched on or rebooted is the following:
Autoselect LED blinks twice
→ All the LEDs are lit → VGA, DP and HDMI video LEDS are
off for 1 sec → VGA LED blinks once the first number (1) → DP LED stays dark showing
the second number
(0) → HDMI LED blinks twice showing the third number (2) → Front
panel LEDs are off → Last state of the device is restored and displayed on the LEDs.
1.0.1
1.0.2
Summary of Contents for UMX-TPS-TX120
Page 2: ......
