Page 68 / 127
Section 7.
LW2 Programmer’s reference
7.3.2. Mute specified output
Description
: Mute output <out>. The output signal is turned off.
Format
Example
Command {#<out>
●<layer>}
→ {#01 A}
Response
(1MT<out²>●<layer>)CrLf
← (1MT01 A)CrLf
Explanation
: The audio channel of the TPS output is muted.
Legend
on page
Info:
Muting does not change the crosspoint’s state, but disables the output itself. This way the
last connection can be easily restored with an unmute command.
Info: Switching a muted output does not unmute the output.
7.3.3. Unmute specified output
Description
: Unmute output <out>.
Format
Example
Command {+<out>
●<layer>}
→ {+01 A}
Response
(0MT<out²>●<layer>)CrLf
← (0MT01 A)CrLf
Explanation
: The audio channel of the TPS output is unmuted.
Legend
on page
Info: Unmut
ing an output makes the previous connection active as the crosspoint’s state has not
been changed with the muting command, only the output was disabled.
7.3.4. Lock the output
Description
: Lock output <out>. Output’s state cannot be changed until unlocking.
Format
Example
Command {#><out>
●<layer>}
→ {#>01 A}
Response
(1LO<out²>●<layer>)CrLf
← (1LO01 A)CrLf
Explanation
: Audio channel of the TPS output is locked.
Legend
on page
7.3.5. Unlock the output
Description
: Unlock output <out>. The connection on output can be changed.
Format
Example
Command {+<<out>
●<layer>}
→ {+<01 A}
Response
(0LO<out²>●<layer>)CrLf
← (0LO01 A)CrLf
Explanation
: Audio channel of the TPS output is unlocked.
Legend
on page
Info: The device issues the above response regardless of the previous state of the output (either
it was locked or unlocked).
Summary of Contents for UMX-TPS-TX120
Page 2: ......
