Page 28 / 127
Section 4. Installation
4.3. Connecting steps
– using local PSU
Figure 4-3. UMX-TPS-TX1x0
– Powered by a local adaptor
Step 1.
Connect the transmitter and the receiver by a CATx cable via the TPS connectors.
Step 2.
Connect the desired video and audio source(s) to the input port(s) of the transmitter.
Step 3.
Optionally connect the transmitter to a Local Area Network (LAN) in order to control
the device. More information about establishing the connection can be found in
section
Step 4.
Optionally connect a serial device
to the transmitter’s RS-232 port.
Step 5.
Optionally for Infra-Red extension:
Connect the IR emitter to the IR OUT port of the transmitter.
Connect the IR detector to the IR IN port of the transmitter.
Step 6.
Connect the power cord of the supplied adaptor to the transmitter or use
Lightware’s rack mountable power supply unit.
Step 7.
Power on the devices.
Info: When both local adaptor and remote power injector are connected to UMX-TPS-TX1x0,
the power injector will be used as a power source.
4.4. Connecting steps
– using power injector (TPS-PI-1P1)
Figure 4-4. WP-UMX-TPS-TX130-US
– Powered remotely
Summary of Contents for UMX-TPS-TX120
Page 2: ......
