UMX-TPS-TX100 series
User’s Manual
Section 6. Software control
– using Lightware Device Controller (LDC)
Page 49 / 127
6.6.6. TPS output port properties and mode settings
Muting/Locking
TPS output can be muted by clicking on the button Unmuted. If the output is muted, button
text is Muted. When the port is muted, no signal is present on the output.
TPS output can be locked by clicking on the button Unlocked. If the output is locked, button
text is Locked. If the port is locked, its mute state cannot be changed either by the button,
or by loading a preset.
Autoselect
The autoselect feature can be set via the TPS
OUT properties panel. The Autoselect section
contains the following settings:
Settings
Enabled: The Autoselect mode is ON.
Disabled: The Autoselect mode is OFF.
Priority detects: Priority detect mode is
active (see section
on page
First detect: First detect mode is active
(see section
on page
Last detected: Last detect mode is active
(see section
on page
Static: Static mode is active (see section
). Available only at TPS
Audio out.
Always press the Set button after the modification
to store the settings.
Input priorities
The available input ports are listed; each one has
its own priority number (equal numbers are
allowed). If you want to disable a port from the
priority list, uncheck the setting next to the priority
number and the priority number will be emptied
and disabled. Smaller number means higher
priority as usual. Priority 31 is the lowest priority,
in this case the port will not be checked and will
not be on the priority list.
Always press the Set priorities button after the modification to store the settings.
Cable diagnostics (only on TPS Video output port)
The estimated cable length and the quality of the link are
measured periodically and the diagnostic window shows
the values in real-time. If the green bars hit the first line
in the middle they turn into red. It means the number of
the errors
– during the extension – is higher than the
recommended one. The link might be alive but
recovering of the received data is not guaranteed.
Info: Each bar represents a differential line in the CATx cable.
The inappropriate termination of the cable usually occurs high error rates. Check the cable
terminations or change the cable.
Info: The estimated length is valid for Cat5e AWG24 cables. Cat7 cable length is calculated from
the measurement of Cat5e AWG24 cable.
Summary of Contents for UMX-TPS-TX120
Page 2: ......
