Page 62 / 127
Section 6. Software control
– using Lightware Device Controller (LDC)
Clear all events
All events can be cleared at the same time with the loading
factory default values. All the values will be cleared: names,
conditions, actions. Click on the Load factory defaults button. A warning message appears.
Confirm it by clicking on the OK button.
6.10. Settings menu
Device status information and network settings are available in this menu, function buttons
help to do operations in connection with logs and device settings.
6.10.1. Status tab
General information is shown on this tab, such as device label, part number, serial number
and hardware health, voltage and temperature values.
Figure 6-9. Status tab
6.10.2. Network tab
Network-related settings are available on the tab.
Figure 6-10. Network tab
The first three (two) lines are valid when the device has a fix IP address. If dynamic IP
address is used, the DHCP setting shall be set to be enabled and the assigned IP
parameters are indicated below the DHCP setting drop-down menu. The device is able to
communicate with LW2 and LW3 protocols, the ports can be set here.
Info: Connecting to the transmitter via Ethernet and using LW2 port nr. (default is 10001) the
device will accept LW2 protocol commands. Using LW3 port nr. (default is 6107) the device
will accept LW3 protocol commands.
Always press the Apply changes button after modification to store the settings; you will be
prompted to reboot the device to apply changes in practice.
Load factory defaults
Summary of Contents for UMX-TPS-TX120
Page 2: ......
