Page 16 / 127
Section 2. Controls and connections
2.2. Front view legend
VGA in
Connect a VGA cable between the analog video source and the
transmitter unit. Using a VGA cable where all the pins are wired
(DDC channel) is highly recommended. Pin assignment can be
found in section
on page
Audio in / Audio1 in
3.5 mm Jack connector for asymmetric analog audio input signal.
Pin assignment can be found in section
HDMI in
Connect a HDMI cable between the source and the transmitter.
Applied cable shall not be more, than 30 m (when signal is
1080p) and 15 m (when signal is 4K). Pin assignment can be
found in section
on page
Status LEDs
The LEDs give feedback about the state of the unit, the video and
audio signals. For more information see section
Video select
Switching among video inputs is available with this button.
Reset
Reset button reboots the extender. This is the same as
disconnecting the device from the power source and
reconnecting it again.
Audio select
Switching between audio inputs is available with this button.
Show me
Special functions are available with this button (switch to
bootload mode, enable DHCP, restore factory default settings).
For details about the special functions see the section
DP in
DisplayPort input connector (only on UMX-TPS-TX140 and
WP-UMX-TPS-TX130-US). Applied cable shall not be more, than
30 m (at 2.7 Gbps data speed). Pin assignment can be found in
section
Ethernet
Front-side locking RJ45 connector (only on WP-UMX-TPS
transmitters) for Ethernet communication. The typical way of
installation is when LAN is connected to the receiver side, and
the Ethernet port on the wall plate can be used for a Laptop or
PC.
Important! Please do not cover the ventilation holes on the front panel of the wall plates; ensure the
proper airflow.
6
4
2
3
1
5
7
8
9
10
Summary of Contents for UMX-TPS-TX120
Page 2: ......
