Page 38 / 127
Section 5. Front panel operations
5.6. Special functions
5.6.1. Control lock
Press the Audio select and Show Me buttons together (within 100 ms) to disable/enable
front panel buttons; front panel LEDs blink 4 times when locking/unlocking. If the control
lock is enabled and a button is pressed, front panel LEDs blink 3 times.
5.6.2. Reset to factory default settings
If factory default values have to be restored, do the following steps:
Step 1.
Make sure the device is powered on and operational (control is not locked).
Step 2.
Press and keep pressed the Show me button for 10 seconds.
Step 3.
After 5 seconds front panel LEDs start blinking but keep on pressing the button.
Step 4.
After 10 seconds the blinking gets faster; release the button and press it 3 times
again quickly (within 3 seconds).
Step 5.
The LEDs get dark, the device restores the factory default settings and reboots.
Factory default settings are listed in section
5.6.3. Enable DHCP IP address
The device gets a fix IP address as a factory default setting. If this setting does not fit to
the circumstances during install or usage, DHCP can be enabled from the front panel:
Step 1.
Make sure the device is powered on and operational (control is not locked).
Step 2.
Press and keep pressed the Show me button for 5 seconds.
Step 3.
After 5 seconds front panel LEDs start blinking; release the button and press it 3
times again quickly (within 3 seconds).
Step 4.
The LEDs get dark, DHCP gets enabled and the device reboots.
5.6.4. Entering bootload mode
It may happen that the firmware upgrade process is not successful as the device cannot
be switched to bootload mode automatically. In this case transmitter device can be forced
to switch to bootload mode as follows:
Step 1.
Make sure the transmitter is powered off.
Step 2.
Press and keep pressed the Show me button.
Step 3.
Power on the transmitter. If the device is switched to bootload mode:
a)
The LIVE LED is blinking quickly on UMX-TPS transmitters.
b)
The AUTOSELECT LED is blinking quickly on WP-UMX-TPS transmitters.
The other LEDs are off.
Info: Device can be switched to normal operation mode by resetting or switching it off and on
again.
Summary of Contents for UMX-TPS-TX120
Page 2: ......
