Page 32 / 127
Section 5. Front panel operations
5.3. Input port selection
The transmitters accept many video and audio input signals depending
on the model’s
capabilities. The audio/video input can be selected by any of the following ways:
Pressing the Audio select / Video select button,
Using the Autoselect function,
Using Lightware Device Controller,
Sending LW2 or LW3 protocol command.
The transmitter can receive LW2 or LW3 command through Ethernet or RS-232 interface,
which can be either local or remote. It means that the input selection can also be controlled
remotely from a TPS receiver’s RS-232 or Ethernet port.
Only one video and audio can be selected to transmit; below figure shows the block
diagram of input/output selection.
Figure 5-1. Input port selection
– summary of UMX-TPS transmitters
Figure 5-2. Input port selection
– summary of WP-UMX-TPS transmitters
Summary of Contents for UMX-TPS-TX120
Page 2: ......
