55
206-4202
Configuration Options via Command Line (Cont.)
(Continued from previous page)
2. At the
Use NTP for time synchronization (Y/N) ? [Y]:
prompt, either:
• Type
y
and press
Enter
if you intend to use an NTP client for time synchronization.
At the
Enter new NTP server IP: [64.90.182.55]:
prompt, either press
Enter
to accept the default value in square brackets, or type the appropriate NTP client IP
address and press
Enter
.
The system will display confirmation for example:
Time will now be synchronized via NTP from server:
xxx
.
xxx
.
xxx
.
xxx
(where
xxx.xxx.xxx.xxx
is the NTP client IP address you provided above)
• Type
n
and press
Enter
to set the time manually.
The system will display the current time, for example:
Current time: 2012-02-16 18:49:56
and then initiate a series of prompts to enable you to set the time. Continue with step 3.
3. At each of the following prompts, type the year, month, and day, respectively. Note that all
three of these fields require numerical values. Press
Enter
after each entry.
If applicable, you can also press
Enter
at each prompt to accept the default value in square
brackets.
Enter new year [2012]>
Enter new month [2]>
Enter new day [16]>
4. At each of the following prompts, type the hour and minute, respectively. Note that the hour
should be entered in 24-hour format. Press
Enter
after each entry.
If applicable, you can also press
Enter
at each prompt to accept the default value in square
brackets.
Enter new hour [18]>
Enter new minute [49]>
5. The system will display the new time and then prompt for confirmation, for example:
New time: 2012-02-16 18:53:00
Apply? [y/n]
Either, type
y
and press
Enter
to apply the new configuration to the system, or type
n
and press
Enter
to return to the
Setup Command >
prompt without changing the time
configuration.
If you do apply new manual configuration, the system will display confirmation, for example:
New time is set