50
206-4202
Configure the RF Output
This option enables you to specify the appropriate RF channels for your location. See
“Channel Assignments for RF Output” on page 9, and/or check with your service representative,
if necessary.
Note:
Ensure the output mode also has been set accordingly. See “Set the Output Mode” on
page 47 for further information.
1. At the
Setup Command >
prompt, type
rf
and press
Enter
.
The system displays a list of the RF mode options and prompts for a selection:
RF Setup
Available RF modes are:
1) RF: OFF
2) QAM-B, RF: 6 MHz, 5.36 MSps
(default)
Select a new RF mode [2]:
2. At the prompt for the RF mode, either:
• Type
1
and press
Enter
to disable RF output.
• Type
2
and press
Enter
to enable RF output.
Note:
You can simply press
Enter
if the default shown in square brackets is the correct op-
tion for this system.
3. If you selected the RF output (QAM-B) option in step 2, the system will prompt next for an RF
channel number (i.e., the RF start channel number):
Enter a new RF channel [3]:
At the prompt, either press
Enter
to accept the default value in square brackets, or type a
new RF start channel number and then press
Enter
.
4. At the
Enter number of channels [4]:
prompt, either press
Enter
to accept the
default value in square brackets, or type the applicable number of channels (Maximum = 4).
Once you specify the RF setup, the system displays an overview of the settings, for example:
RF config: Mode 2, QAM-B, RF: 6 MHz, 5.36 MSps
RF channels: 7 8 9 10
Configure the IP Output
IP Output Configuration Menu options enable you to view and/or modify the IP output
configuration for your system. Each of the menu options is described below.
Note:
Ensure the output mode also has been set accordingly. See “Set the Output Mode” on
page 47 for further information.
Configuration Options via Command Line (Cont.)