19
206-4202
System Setup (Cont.)
(Continued from previous page)
Note:
If you set a new STB type, you will be prompted to reset the system. If you intend to
modify additional configuration settings during the current session, you may wait until all
changes are complete before you reset the system.
17. If the
Setup Command >
prompt is on display, type
exit
and press
Enter
to return to the
Command >
prompt.
18. Set the channel(s) on each of the installed STBs as follows:
a) At the
Command >
prompt, type
stb
and press
Enter
to
access the STB Menu.
b) At the
Enter STB number >
prompt, type the number of the PIVD100R X-Port
connected to the STB for which you wish to set the channel(s). Then, press
Enter
.
The system will identify the current STB and then display an STB command prompt,
for example:
Current STB: STB-1
STB-1 Command >
c) Use the STB Menu “channel” command, as described on page 42, to set the STB/
tuner channel. If applicable, make sure to set the channel for both STB tuners.
d) Use the STB Menu “stb” command, as described on page 41, to access the STB Menu
for the next STB for which you wish to set the channel(s). Then, use the “channel”
command to set the channel(s) for the (newly) current STB.
Repeat this step to set the channel on each STB/tuner.
19. At the
STB Command >
prompt, type
exit
and press
Enter
to return to the
Command >
prompt.
20. (Optional) If you wish to review the system settings at this time, at the
Command >
prompt, type
info
and press
Enter
to display the system information.
Note:
You can also run the “monitor” command, if desired, to review the system settings.
See “Monitor the System” on page 38 for further information.
21. At the
Command >
prompt, type
reset
and press
Enter
to reset the system.
Note:
This initiates a reset of the PIVD100R and may also initiate a reset of one or more
STBs, if required. Once the PIVD100R is reset (may take up to 90 seconds), it may then
take up to 10 minutes for the PIVD100R to reestablish communication with the STBs. After
the system reset, the PIVD100R resumes normal operation.
22. Check one or more room receivers to make sure all content is properly mapped and
available.