
16
206-4202
(Continued from previous page)
8. At the
Command >
prompt, type
info
and press
Enter
. (Note that you can press
Enter
at
any PIVD100R command prompt to view current menu.)
The initial System Information display identifies PIVD100R default configuration settings,
including the Control Port IP address, the STB type, and the output configuration, for
example:
PIVD100R
Pro:Idiom Video Distribution Transcoder System
Copyright (c) 2010-2012 LG Electronics U.S.A., Inc.
Copyright (c) 2010-2012 Zenith Electronics LLC
SN: 101-12470001
Version
1.5
HW id:
3-207-79-4
Ctrl MAC: 00:0C:63:3B:00:BE
Ctrl IP: 136.166.60.92
STB Type:
DirecTV
Output:
RF
RF config: Mode 2, QAM-B, RF: 6 MHz, 5.36 MSps
RF channels: 3 4 5 6
Local time: Thu Mar 22 14:42:02 CDT 2012
9. Check the Ctrl IP (Control Port IP address) field in the System Information display. By
default, the PIVD100R uses DHCP; thus, the DHCP server, if configured, assigns an IP
address to the PIVD100R once the PIVD100R successfully connects to the network.
• If the Ctrl IP field shows an IP address, the PIVD100R is up and running on the network.
Continue with step 10.
• If the network is configured for DHCP but the Ctrl IP field is blank, refer to “Network Setup”
troubleshooting information on page 61.
• If the network is not configured for DHCP, you will need to configure a static IP address
for the PIVD100R. Complete steps 10 to 13 (as required), and then set the PIVD100R IP
address using the commands indicated in step 14.
10. Check the Output field in the System Information display. If the default value (RF) does not
identify the appropriate output type, set the output mode as follows:
a) At the
Command >
prompt, type
setup
and press
Enter
to
access the Setup Menu.
b) Use the Setup Menu “omode” command, as described on page 47, to set the appropriate
output mode.
11. The next step depends on the output mode:
• If you are setting up the system for RF output, continue with step 12.
• If you are setting up the system for IP output, go to step 13.
System Setup (Cont.)
(Continued on next page)