52
206-4202
(Continued on next page)
(Continued from previous page)
2. At the
Enter STB number [#]>
command, type the number of the PIVD100R X-Port
connected to the STB for which you wish to modify configuration. Then, press
Enter
.
3. (Dual tuner STB only) At the
Enter tuner number (1 or 2) [1]>
command, either
press
Enter
to accept the default value in square brackets, or type the appropriate tuner
number and press
Enter
.
4. At the
Enter multicast IP address [227.0.0.0]:
command, either press
Enter
to accept the default value in square brackets, or type the appropriate multicast IP address
for this stream and press
Enter
.
5. At the
Enter new multicast port [1234]>
command, either press
Enter
to accept
the default value in square brackets, or type the appropriate port number for the multicast
stream and press
Enter
.
6. After you type the port number, the system returns to the
IP Output Command >
prompt. To configure additional IP channels, repeat steps 1 to 5.
7. When you have set all output IP channels as required, type
apply
and press
Enter
at the
IP Output Command >
prompt to confirm and apply the configuration data to the system.
The system will display confirmation before returning to the
IP Output Command >
prompt, for example:
New IP outputs configuration is now active.
8. At the
IP Output Command >
prompt, type
exit
and press
Enter
to return to the Setup
Menu.
Auto-configure Output IP Channels
This option enables you to have the system auto-increment the output IP channels from a
base multicast IP address and port number. Each program must be assigned a unique IPv4
multicast address. See “Channel Assignments for IP Output” on page 9, and/or check with your
service representative, if necessary.
Note:
If you wish to manually configure each IP channel, use the “set” option described above.
1. At the
IP Output Command >
prompt, type
fill
and press
Enter
.
2. At the
Enter base multicast IP address [227.0.0.0]:
command, either press
Enter
to accept the default value in square brackets, or type the appropriate base multicast
IP address and press
Enter
.
3. At the
Enter new multicast port [1234]
prompt, either press
Enter
to accept the
default value in square brackets, or type the appropriate port number for the multicast
streams and press
Enter
.
Configuration Options via Command Line (Cont.)