LG 50PC1DR - - 50" Plasma TV, Training Manual

Page: 68 / 138

Plasma Training
68
Disassembly
DISASSEMBLY
PANEL REMOVAL
At this point, replace the panel if it has been determined to be defective and replacement is
necessary.
1) Remove the four (4) screws that retain the panel to the front cabinet assembly.
2) Remove the support rails screws indicated. Removing these screws will release the panel from
the cabinet.
3) Using the support rails, lift the defective panel up and out of the cabinet.
4) Place the panel on a flat padded surface away from the cabinet.
5) Remove the two (2) bolts fastening each support rail to the back of the defective panel. The
right side support rail has a cooling fan attached to it. It can remain attached through the
removal from the defective panel and re-installation to the placement panel.
INSPECT REPLACEMENT PANEL
Upon receiving the replacement panel, it must be inspected to ensure that it has arrived in good
condition. The following items should be observed to ensure that no shipping damage has occurred.
1) Check the outer carton for damage, and report it upon receipt
of the replacement panel.
2) Confirm the part number on the carton label is the part
number that was ordered or expected.
3) If the carton has arrived undamaged, open the carton after
receipt, and check the contents for damage or broken parts.
4) Confirm the replacement panel in the carton matches the
part number on the outer carton.
5) If everything is correct and un-damaged, the panel
replacement process can continue at this point.