Lexmark C 540n, Service Manual

Page: 144 / 262

4-2
Service Manual
5025-2xx, 4xx
Removal procedures
Notes:
•
Remove the waste toner bottle, color toner cartridges, imaging unit, and media tray before removing other
printer parts. The imaging unit should be carefully set on a clean, smooth, and flat surface. It should also
be protected from light while out of the printer.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held with several screws, start all screws before final tightening.
•
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Front cover assembly removal
See the front cover assembly on page 7-3 for the part number.
1.
Open the front cover.
2.
Remove the operator panel. See “Operator panel logo plate” on page 4-9 .
3.
Remove the right cover assembly. See “Right cover assembly removal” on page 4-12 .
4.
Remove the waste toner bottle. See “Waste toner bottle removal” on page 4-77 .
5.
Remove the four screws (A) from the cable cover, and remove the cable cover.
6.
Remove the screw (B) from the back of the waste toner cartridge ground connector.
7.
Remove the rear shield. See “Top cover assembly removal” on page 4-13 .
CAUTION
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly for personal safety and to prevent damage to the printer.
Disconnect any connections between the printer and PCs/peripherals.
A B