Lexmark 13P0150 - C 750dtn Color Laser Printer, Service Manual

Page: 57 / 262

Diagnostic Information
2-37
5060-XXX
52 Flash Full This message will be displayed when there is not
enough free space in the flash memory to hold
the resources that have been requested to be
written to flash.
Note: The following action will delete all
downloaded Fonts and Macros written to disk:
*Press Go to clear the message and continue
processing the print job.
* Press >Menu or Menu< to access the Busy/
Waiting Menu group
The following functions may be available:
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
53 Unformatted Flash This message will be displayed when the printer
detects an unformatted flash at POST.
The following actions can be taken while this
message is displayed:
* Press Go to clear the message.
The flash will be marked bad and normal
operation will continue. Flash operations will not
be allowed until the flash is formatted.
54 Std Par ENA
Connection Lost This message will be displayed when the printer
detects during POST that the connection to an
ENA has been lost. Once a connection is initially
established, a printer setting is modified to 54 Par
x ENA to note a connection exists. Each time the
power is cycled on, the connection is lost.
54 Std Network
Software Error This message will be displayed when the RIP
software has detected that a network port is
installed but cannot establish communications
with it.
54 Network x Software
Error The following actions can be taken while this
message is displayed:
* Press Go to clear this message.
The printer will disable all communications to the
associated network interface. No data may be
received or sent from or to the associated
interface. The user cannot program new firmware
in the network via the parallel port after this
message has been cleared.
User Primary
Message
User Secondary Message Explanation