Lexmark 13P0150 - C 750dtn Color Laser Printer, Service Manual

Page: 26 / 262

2-6
Service Manual
5060-XXX
958 NAND Failure Replace the “RIP Board” on page 4-11 .
960 RAM Memory Error RAM soldered on board is bad. Replace the “RIP Board” on
page 4-11 .
961 RAM Memory Error Errors 961 through 963 indicate that a memory error has occurred
on RAM x in slot x installed on the RIP card. If available, switch
memory from the failing slot with one from a non-failing slot to see
if this fixes the problem. If it does not fix the problem, replace the
“RIP Board” on page 4-11 . If it does fix the problem replace the
defective RAM.
962 RAM Memory Error
963 RAM Memory Error
964 Emulation Error Download Emulation CRC failure has occurred.
975 Standard Network
or
Network Card X Unrecognizable network Errors 975 through 979 indicate a failure
with the standard network port located on the controller board or a
network card in the specified slot x, x=1, 2 or 3.
975 Network Card X
976 Standard Network Unrecoverable software or error in network port. Network Card X
978 Standard Network
or
Network Card X Bad checksum while programming network Network Card X port.
979 Standard Network
or
Network Card X Flash parts failed while programming network Network Card X
port.
980 <device> comm Engine is experiencing unreliable communications to the specified
device.
Errors 980 through 984 indicate the specified device has detected
a Paper Port communication failure.
981 <device> comm Engine protocol violation detected by the specified device.
* Engine
* Duplex unit
* Tray x (where x=1,2,3,4, or 5)
982 <device> comm Communications error detected by the specified device.
* Output Bin (where x=1,2,3,or 6)
Note: This message is used for single bin output devices.
* Bins x to y (where x to y= 1 to 5, 2 to 6, or 6 to 10)
983 <device> comm Invalid command received by the specified device. Note: This
message is used for multiple bin output devices.
Note: Check the autoconnects above and below the failing option
to make sure they are seated and connected correctly. Go to the
service check for the device indicated.
984 <device> comm Invalid command parameter received by the specified device.
Error code Action