Lexmark 13P0150 - C 750dtn Color Laser Printer, Service Manual

Page: 55 / 262

Diagnostic Information
2-35
5060-XXX
37 Insufficient Defrag
Memory This message will be displayed when insufficient
printer memory is available to perform Flash
Memory Defragment operation.
Note: This message sill be posted prior to the
actual start of the defragment operation.
The following actions can be taken while this
message is displayed:
* Press Go to clear the message.
To perform the defragment operation you can:
* Delete fonts, macros and other data in RAM
* Install additional printer memory
* Press Menu> or Menu< to access the Busy/
Waiting Menu Group.
The following functions will be available via the
Busy/Waiting Menu:
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
37 Insufficient Memory Held Jobs May Not be
Restored These messages may be displayed when the
printer has attempted to Print and Hold jobs from
the disk and found that some or all of the jobs
could not be restored. Each of the three
messages 57 Configuration Held Jobs May
describe different conditions under which the
restore failed.
Primary Message: 37 Insufficient Memory. The
printer firmware ran out of memory while
attempting to restore the jobs.
Secondary Message: Held Jobs May Not Be
Restored.
Primary Message: 57 Configuration Change -
The printer firmware could not restore jobs from
the disk because the configuration of the printer
has changed.
Secondary Message: Held Jobs May Not Be
Restored.
Primary Message: Held Jobs May Not Be
Restored handles any other conditions where any
of the Print and Hold jobs could not be restored
from the disk.
Note: Some of the Print and Hold jobs may not be
restored. They will remain on the disk but cannot
be accessed.
User Primary
Message
User Secondary Message Explanation