Lenovo ThinkServer RS140, User Manual And Hardware Maintenance Manual

Page: 79 / 146

6. Locate the TR 500 key connector on the ThinkServer RAID 500 Adapter and then carefully insert the
TR 500 Key into the connector. If necessary, you can remove the ThinkServer RAID 500 Adapter first,
install the TR 500 Key on it, and then reinstall the ThinkServer RAID 500 Adapter. See “Installing or
removing the RAID card” on page 62.
Note: Ensure that the TR 500 Key is securely seated on the ThinkServer RAID 500 Adapter.
Figure 37. Installing the TR 500 Key
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 106. Then, the hardware
RAID 5 is available for your server if your server has the required number of hard disk drives installed.
Refer to the
MegaRAID SAS Software User Guide on the documentation DVD that comes with your server
for information about how to configure the hardware RAID.
Removing the TR 500 Key
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 53.
Attention: Back up your data before you begin if you need to reconfigure RAID and reinstall the operating
system after removing the TR 500 Key.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• If you remove the TR 500 Key, the hardware RAID 5 will be disabled.
• Use any documentation that comes with the TR 500 Key and follow those instructions in addition to
the instructions in this topic.
To remove the TR 500 Key, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
Chapter 6
.
Installing, removing, or replacing hardware
67