Lenovo HR650X V2, User Manual

Page: 96 / 192

– “DRAM DIMM installation order” on page 88 (RDIMMs)
– “PMEM and DRAM DIMM installation order” on page 91
• A label on each DIMM identifies the DIMM type. This information is in the format xxxxx n Rxxx PC4-
xxxxx-xx-xx-xxx . Where n indicates if the DIMM is single-rank (n=1) or dual-rank (n=2).
• At least one DIMM is required for each processor. Install at least six DIMMs per processor for good
performance.
• When you replace a DIMM, the server provides automatic DIMM enablement capability without requiring
you to use the Setup utility to enable the new DIMM manually.
Attention:
• Mixing x4 and x8 DIMMs in the same channel is allowed.
• Install DIMMs of the same speed for optimal performance. Otherwise, the BIOS will find and run the
lowest speed among all channels.
• Always populate DIMMs with the maximum number of ranks in the farthest DIMM slot, followed by the
nearest DIMM slot.
DRAM DIMM installation order
For RDIMMs, the following memory modes are available:
• “Independent mode” on page 88
• “Mirroring mode” on page 89
Independent mode
In independent memory mode, memory channels can be populated with DIMMs in any order and you can
populate all channels for each processor in any order with no matching requirements. Independent memory
mode provides the highest level of memory performance, but lacks failover protection. The DIMM installation
order for independent memory mode varies based on the number of processors and memory modules
installed in the server.
Follow the rules below when installing memory modules in independent mode:
• All memory modules to be installed must be of the same type. x4 and x8 DIMMs can be mixed in the same
channel.
• Memory modules from different vendors are supported.
• There must be at least one DDR4 DIMM per socket.
• In each memory channel, populate slot 0 first.
• If a memory channel has two DIMMs, populate the DIMM with a higher number of ranks in slot 0; if the two
DIMMs have the same number of ranks, populate the DIMM with a higher capacity in slot 0.
• A maximum of 8 logical ranks (ranks seen by the host) per channel is allowed.
• A maximum of two different DIMM capacities are supported per system.
– For channels A, C, E, and G, populated DIMMs must have the same total capacity for each channel.
– For channels B, D, F, and H, populated DIMMs must have the same total capacity for each channel,
which can be different from that of the other set (channels A, C, E, and G).
• If there are more than two DIMMs, populate them in a right-and-left symmetrical manner across a CPU
socket.
With one processor
The following table shows the sequence of populating memory modules (with the same capacity ) for
independent mode when only one processor (Processor 1) is installed.
88
HR650X V2 User Guide