Lenovo Flex System Fabric CN4093, Application Manual

Page: 94 / 634

94
CN4093 Application Guide for N/OS 8.4
End User Access Control
Enterprise NOS allows an administrator to define end user accounts that permit
end users to perform operation tasks via the switch CLI commands. Once end user
accounts are configured and enabled, the switch requires username/password
authentication.
For example, an administrator can assign a user, who can then log into the switch
and perform operational commands (effective only until the next switch reboot).
Considerations for Configuring End User Accounts
 A maximum of 20 user IDs are supported on the switch.
 Enterprise NOS supports end user support for Console, Telnet, BBI, and
SSHv1/v2 access to the switch.
 If RADIUS authentication is used, the user password on the Radius server will
override the user password on the CN4093. Also note that the password change
command modifies only the user switch password on the switch and has no
effect on the user password on the Radius server. Radius authentication and
user password cannot be used concurrently to access the switch.
 Passwords can be up to 64 characters in length for Telnet, SSH, Console, and
Web access.
Strong Passwords
The administrator can require use of Strong Passwords for users to access the
CN4093. Strong Passwords enhance security because they make password
guessing more difficult.
The following rules apply when Strong Passwords are enabled:
 Minimum length: 8 characters; maximum length: 64 characters
 Must contain at least one uppercase alphabet
 Must contain at least one lowercase alphabet
 Must contain at least one number
 Must contain at least one special character:
Supported special characters: ! “ # % & ‘ ( ) ; < = >> ? [\] * + , ‐ . / : ^ _ { | } ~
 Cannot be same as the username
When strong password is enabled, users can still access the switch using the old
password but will be advised to change to a strong password while attempting to
log in.
The strong password requirement can be enabled using the following command:
CN 4093(config)# access user strong-password enable