Lenovo Flex System Fabric CN4093, Application Manual

Page: 64 / 634

64
CN4093 Application Guide for N/OS 8.4
Setup Part 2: Port Configuration
Note:
When configuring port options for your switch, some prompts and options
may be different.
1.
Select whether you will configure VLANs and VLAN tagging for ports:
If you wish to change settings for VLANs, enter
y
or enter
n
to skip VLAN
configuration.
Note:
The sample screens that appear in this document might differ slightly from
the screens displayed by your system. Screen content varies based on the type of
chassis unit that you are using and the firmware versions and options that are
installed.
2.
Select the port to configure, or skip port configuration at the prompt:
If you wish to change settings for individual ports, enter the number of the port
you wish to configure. To skip port configuration, press
<Enter>
without
specifying any port and go to “Setup Part 3: VLANs” on page 66 .
3.
Configure Gigabit Ethernet port flow parameters.
The system prompts:
Enter
rx
to enable receive flow control,
tx
for transmit flow control,
both
to enable
both or
none
to turn flow control off for the port. To keep the current setting, press
<Enter>
.
4.
Configure Gigabit Ethernet port autonegotiation mode.
If you selected a port that has a Gigabit Ethernet connector, the system prompts:
Enter
on
to enable port autonegotiation,
off
to disable it or press
<Enter>
to keep
the current setting.
Port Config:
Will you configure VLANs and Tagging/Trunk-mode for ports? [y/n]
Gig Link Configuration:
Port Flow Control:
Current Port EXT1 flow control setting: both
Enter new value ["rx"/"tx"/"both"/"none"]:
Port Auto Negotiation:
Current Port EXT1 autonegotiation: on
Enter new value ["on"/"off"]: