Lenovo Flex System Fabric CN4093, Application Manual

Page: 556 / 634

556
CN4093 Application Guide for N/OS 8.4
SNMP Version 1
To access the SNMP agent on the CN4093, the read and write community strings
on the SNMP manager should be configured to match those on the switch.
The read and write community strings on the switch can be changed using the
following commands:
The SNMP manager should be able to reach the management interface or any one
of the IP interfaces on the switch.
For the SNMP manager to receive the SNMPv1 traps sent out by the SNMP agent
on the switch, configure the trap host on the switch with the following command:
Note:
You can use a loopback interface to set the source IP address for SNMP
traps. Use the following command to apply a configured loopback interface:
CN 4093(config)#
snmp-server trap-source loopback
<1 ‐ 5>
CN 4093(config)# snmp-server read-community
<1 ‐ 32 characters>
‐ and ‐
CN 4093(config)# snmp-server write-community
<1 ‐ 32 characters>
CN 4093(config)# snmp-server trap-source
<trap source IP interface>
CN 4093(config)# snmp-server host
<IPv4 address> <trap host community string>